Installation guide

INSTALLATION AND SAFETY INSTRUCTIONS

OR YOUR SAFETY

ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

RE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

teps in the order given. Read instructions carefully.

f you are unclear

as to how to proceed, consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of

this fixture.

arefully remove the fixture from the carton and check that

all parts are included, as shown in Figures 1 & 2. Be careful

ot to misplace any of the screws or parts which are needed

to install this fixture.

TEP 1:

GLASS (B)

CAP NUTS (N)

GLASS

RETAINING

RING (C)

FRONT PLATE (M)

Installation And

Safety Instruction

HC-991

080106

ill In Item Number On Carton

And

File This Sheet For Fixture Reference. ITEM#_________

Line art shown may not exactly match the fixture enclosed.

However

, the installation instructions do apply to this fixture.

*NOT SUPPLIED

(FIG. 1)

*NOT SUPPLIED

FIGURE 2

* WIRE

CONNECTOR

FRONT PLATE

(DECORATIVE FRONT)

*ROMEX/BX

CONNECTOR

BACK PLATE

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF . GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician. NOTE: Proper wiring is essential for the safe operation of this fixture.
PAGE 2
INSTALLATION HC-991 IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Punch out appropriate holes in backplate [A], if applicable, to correspond with holes in outlet box. STEP 2: Push socket wires thru plastic bushing (If applicable). STEP 3: A. Take note of the color of the wire(s) on your fixture.