Installation Guide

ManualsBrandsSea Gull Lighting ManualsBathDe-Lovely 6-Light Brushed Nickel Vanity Bar Light

Peel protective coating off as follows: (if applicable). For easier

removal, peel coating off at an angle holding it close to the fixture.

Peel sides off before peeling the front faces.

arefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1. Be careful not to misplace any of

the screws or parts which are needed to install this fixture.

FIGURE 1

FIGURE 2

• Be sure the electricity to the system you are working on is turned off;

either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing and

create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Read instructions carefully

• Proper wiring is essential for the safe operation of this fixture.

• Save these instructions.

NOTE: SOCKETS ARE

FACTORY INSTALLED. IF

SOCKET IS NOT SECURE TO

BACKPLATE, MAKE SURE

SOCKET TABS ARE SNAPPED

ONTO PRE-DRILLED HOLES

IN BACKPLATE.

* WIRE

CONNECTOR

FACE PLATE

*ROMEX/BX

CONNECTOR

*NOT SUPPLIED

* WIRE

CONNECTOR

CUPS (I)

FACE PLATE (F)

GCO GROUND WIRE

(IF APPLICABLE)

DECORATIVE

FRONT (E)

*OUTLET BOX

GROUND WIRE (D)

*OUTLET BOX

BACK PLATE (C)

SOCKETS (J)

EXTRUDED HOLE (B)

GREEN GROUNDING

SCREW (A)

WOOD

SCREWS (K)

BACK PLATE

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-107

80608

STEP 1:

IMPORTANT SAFETY INSTRUCTIONS

BEFORE YOU BEGIN

To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.

Do not use abrasive materials such as scouring pads or powders,

steel wool or abrasive paper.

eep this sheet for future reference, and in case you need to order

replacement parts. Parts for this fixture can be ordered from place of

purchase. Be sure to use exact wording from illustration when

ordering parts.

CLEANING

ORDERING PARTS

Summary of content (2 pages)

PAGE 1
HC-107 Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ ORDERING PARTS IMPORTANT SAFETY INSTRUCTIONS • Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off.
PAGE 2
ALTERNATIVE MOUNTING METHOD (Fig. 2) HC-107 THIS FIXTURE CAN BE MOUNTED TO A WALL WITHOUT AN OUTLET BOX, MAKING THE WIRING CONNECTION BETWEEN THE FACEPLATE AND BACKPLATE. 1. Remove knock-out from the backplate (if applicable), or remove plastic bushing. 2. Install Romex / Bx connector on the backplate. 3. Feed house supply wires through Romex / Bx connector, and secure. 4. Make wiring connection as described in the steps that follow, and tuck the wires between the faceplate and backplate.