Installation Guide

ManualsBrandsSea Gull Lighting ManualsBathDe-Lovely 6-Light Brushed Nickel Vanity Bar Light

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY

ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully. If you are unclear as to how to proceed,

consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

fixture.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1. Be careful not to misplace any of

the screws or parts which are needed to install this fixture.

Peel protective coating off as follows: (if applicable). For easier

removal, peel coating off at an angle holding it close to the fixture.

Peel sides off before peeling the front faces.

STEP 1:

*NOT SUPPLIED

FIGURE 1

*NOT SUPPLIED

FIGURE 2

* WIRE

CONNECTOR

FACE PLATE

CUPS (I)

FACE PLATE (F)

GCO GROUND WIRE

(IF APPLICABLE)

*ROMEX/BX

CONNECTOR

BACK PLATE

Installation And Safety

Instruction

HC-107

100101

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

DECORATIVE

FRONT (E)

* OUTLET BOX

GROUND WIRE (D)

* OUTLET BOX

* WIRE

CONNECTOR

BACK PLATE (C)

SOCKETS (J)

EXTRUDED HOLE (B)

GREEN GROUNDING

SCREW (A)

WOOD

SCREWS (K)

NOTE: SOCKETS ARE FACTORY INSTALLED.

IF SOCKET IS NOT SECURE TO BACKPLATE, MAKE

SURE SOCKET TABS ARE SNAPPED ONTO

PRE-DRILLED HOLES IN BACKPLATE.

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF . Carefully remove the fixture from the carton and check that all parts are included, as shown in Figure 1. Be careful not to misplace any of the screws or parts which are needed to install this fixture. STEP 1: GENERAL You don’t need special tools to install this fixture.
PAGE 2
ALTERNATIVE MOUNTING METHOD (Fig. 2) HC-107 THIS FIXTURE CAN BE MOUNTED TO A WALL WITHOUT AN OUTLET BOX, MAKING THE WIRING CONNECTION BETWEEN THE FACEPLATE AND BACKPLATE. 1. Remove knock-out from the backplate (if applicable), or remove plastic bushing. 2. Install Romex / Bx connector on the backplate. 3. Feed house supply wires through Romex / Bx connector, and secure. 4. Make wiring connection as described in the steps that follow, and tuck the wires between the faceplate and backplate.