Installation Guide

Installation Instructions for

Vivid

990VIVID

UNDERCABINET

GP I :ENERAL RODUCT NFORMATION

This product is safety listed for damp locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the hazards

involved.

Use minimum 90°c supply conductors.

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

Slide the diffuser completely forward so that the front

pins are aligned with the front slots on the fixture.

Rotate the diffuser up to open the fixture.

Slide the diffuser forward so that the back pins are

aligned with the back slots on the fixture.

Remove the diffuser.

Note: Multiple fixtures may be interconnected at any

distance apart in accordance with specifications.NEC

Use the keyhole slots to install the fixture(s).

If using a plug-in wall feed, replace the diffuser (reversal

of section 1A) and skip to section 3.

DIFFUSER

FRONT PIN

FRONT SLOT

BACK PIN

BACK SLOT

Install the Fixture

Remove the fixture cover by squeezing the inside of the

cover to release it.

FIXTURE

COVER

Hard Wire the Fixture

1.0

4927_S, 4937_S

PAGE 1
Installation Instructions for 990VIVID Vivid 4927_S, 4937_S 1.0 UNDERCABINET GENERAL PRODUCT INFORMATION: This product is safety listed for damp locations. This product may be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation. 7400 Linder Ave, Skokie, IL 160077 800.969.3347 www.generationlighting.
PAGE 2
B FLEXIBLE CONDUIT 6 5 4 2 Determine the desired location of the conduit connection and remove one of the knockout from the back of the fixture. 3 Install the conduit adapter to the determined knockout location and feed the flexible conduit and the power lines into the fixture. Secure it by tightening down the screw on the conduit adapter. 4 Push the neutral power line to the wire connector with the pre-installed white wire.