Installation Guide

ManualsBrandsSea Gull Lighting ManualsLightingHighlands 6-Light Regal Bronze Hall-Foyer Pendant

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY

ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Read instructions carefully.

If you are unclear

as to how to proceed, consult a qualified electrician.

arefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

*NOTE: If the following parts are not supplied, or they are

factory assembled; proceed to the next assembly step.

*OUTLET BOX

*WIRE CONNECTORS

CANOPY (E)

MOUNTING BAR (A)

*OUTLET BOX SCREWS

CHAIN (G)

NIPPLE (C)

GREEN

GROUNDING

SCREW (R)

NIPPLE (C)

*OUTLET BOX

SCREWS

MOUNTING

BAR (A)

*WIRE

CONNECTORS

*GROUND WIRE

*OUTLET BOX

GROUNDING AND MOUNTING BAR LOCK UP

FIGURE 2 *NOT INCLUDED

NUT (B)

*NOT SUPPLIED FIG. 1

FIXTURE LOOP (I)

TOP ASSEMBLY

BALL

STUDS

ARMS

WARNING: TO REDUCE THE RISK OF FIRE, ELEC-

TRIC SHOCK OR PERSONAL INJURY, MOUNT TO

OUTLET BOX OR SUPPORTING SYSTEM ABLE TO

SUPPORT THE WEIGHT OF THE FIXTURE.

Installation And

Safety Instruction

HC-527

012606

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

Line art sho

wn ma

y not exactly matc

h the fixture

enclosed. However, the installation instructions do

apply to this fixture.

*GROUND WIRE

NUT (B)

SCREW COLLAR RING (F)

GROUND WIRE (S)

SCREW COLLAR (D)

STEP 1:

Attached top assembly to fixture center column.

STEP 2:

Rotate arms on top assembly.

STEP 3:

Remove (3) ball studs from top of cage.

STEP 4:

Secure arms to fixture cage with ball studs (nut will not be used).

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF . GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.
PAGE 2
HC-527 INSTALLATION IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Secure mounting bar (A) to outlet box with outlet box screws (not supplied). Thread nut (B) on nipple (C) so that 3 threads are exposed above nut (B). Thread nipple (C) into mounting bar (A) and secure with nut (B). Attach screw collar (D) to nipple (C). STEP 2: Using 2 pairs of pliers, open one link of chain (G), and connect to the fixture loop (I) at the top of the fixture.