Installation Guide

ManualsBrandsSea Gull Lighting ManualsCeiling LightsWebster 9.5-in White Traditional Incandescent Flush Mount Light

*PARALLEL WIRE (ROUND & SMOOTH) *PARALLEL WIRE (SQUARE & RIDGED)

LACK WHITE

GROUP A:

CONNECT TO BLACK HOUSE WIRE

GROUP B:

CONNECT TO WHITE HOUSE WIRE

GROUNDING INSTRUCTIONS: The green grounding screw (D) is to

be inserted into the hole with two raised dimples provided on the

mounting bar (A). Wrap the ground wire (M) from the fixture (if

supplied) and the ground wire from the outlet box (bare metal or

green insulated wire) around the green grounding screw (D) on the

mounting bar (A) if uninsulated wire is on the mounting bar (A),

connect the ground wire (M) from the fixture (if supplied) and the

outlet box to it using a small wire connector (not supplied).

NEVER

CONNECT GROUND WIRE TO BLACK OR WHITE POWER

SUPPLY WIRES.

INSTALLATION (continued) HC-167

ake note of the color of the wire(s) on your fixture. Identify which

group your fixture wire(s) falls into and connect the wires according

to the directions below:

STEP 3:

A. Take note of the color of the wire(s) on your fixture. Identify which

group your fixture wire(s) falls into and connect the wires according

to the directions below:

*Note: When parallel wire is used, the tracer wire is square shaped or

ridged and less tracer wire is round in shape or smooth

(Seen best when viewed from wire end). To separate wires, grasp the

ends of each wire and pull apart.

B. Take your fixture wire(s) from group A and place evenly against

the black wire from the outlet box. DO NOT twist wires together

before using wire connectors.

C. Fit a wire connector (not supplied) over the wires and thread the

connector clockwise until you feel a firm resistance.

D. Gently try to remove the wires from the connector, If you can

remove the wires, carefully re-do steps B and C, as above and check

again for a firm connection.

E. Connect the fixtur

e wire from group B to the white wire from the

outlet box in the same manner.

STEP 2:

Thread three diffuser retaining screws (E) in side of canopy (Z).

STEP 4:

Make sure no bare wires can be seen outside wire connectors.

Install lamp (s).

After wires are connected, tuck them carefully inside outlet box. Raise

canopy (Z) to the ceiling allowing for nipple (C) to protrude through

center hole (K) in canopy (Z). Secure in place by

tightening cap nut (F).

Raise diffuser (G) to canopy (Z) and finger tighten retaining screws

(E).

INAL ASSEMBLY

STEP 1:

STEP 2:

STEP 3: