Installation Guide

ManualsBrandsSea Gull Lighting ManualsCommercial Lighting4-Light White Fluorescent Ceiling Fixture

INSTALLATION AND SAFETY INSTRUCTIONS

emove center cover (B) by squeezing cover together and pulling out

of tabs (C).

Remove 7/8" diameter wire exit plug and oval mounting knock-outs by

taking a screwdriver and punching out plug and knock-outs from back

ide of fixture pan (A).

Do not install on a ceiling that would cause the lift and shift

mechanism to disengage (ie. slope ceiling, drop ceiling etc.)

NOTE: FOR FIXTURES PROVIDED WITH 75°C OR 90°C SUPPLY WIRE

WARNING ONLY: RISK OF FIRE. MOST DWELLINGS BUILT BEFORE 1985

HAVE SUPPLY WIRE RATED 60°C. CONSULT A QUALIFIED ELECTRICIAN

BEFORE INSTALLING.

TABS (C)

7/8" WIRE EXIT

MOUNTING HOLE

BALLAST

CENTER COVER (B)

NOTE: Because of the size of this fixture, we recommend two

people to install this fixture.

FIGURE 1

FIGURE 2

DIFFUSER (D)

FIXTURE PAN (A)

IMPORTANT SAFETY INSTRUCTIONS

• Be sure the electricity to the system you are working on is turned off;

either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing and

create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Read instructions carefully

• In order for this lighting fixture to operate properly the buildings

electrical system must be grounded.

• Save these instructions.

ASSEMBLY

STEP 1:

STEP 2:

Installation And Safety

Instruction

HC-1297

092807

Line art shown may not exactly match the fixture enclosed.

However, the installation instructions do apply to this fixture.

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_________

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off. Use of other manufacturers components will void warranty, listing and create a potential safety hazard. If you are unclear as to how to proceed, contact a qualified electrician. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
PAGE 2
INSTALLATION HC-1297 IF SUPPLY WIRES ARE LOCATED WITHIN 3" OF BALLAST, USE WIRE RATED FOR AT LEAST 90°C STEP 1: Determine exact location on ceiling for fixture placement. STEP 2: Feed the black and white ballast wires through the 7/8” wire exit hole of the fixture pan (A). STEP 5: GROUNDING INSTRUCTIONS: The green grounding screw is to be inserted into the hole with two raised dimples provided on the fixture pan.