Installation Guide

GROUP A: CONNECT TO BLACK
HOUSE WIRE
BLACK
WHITE
*
P
ARALLEL WIRE (ROUND & SMOOTH)
*PARALLEL WIRE (SQUARE & RIDGED)
GROUP B: CONNECT TO WHITE
HOUSE WIRE
*NOTE: When parallel wire is used, the tracer wire is square shaped
or ridged, and the less tracer wire is round in shape or smooth. (Seen
best when viewed from wire end.) To separate wires, grasp the ends
of each wire and pull apart.
I
NSTALLATION HC-1297
STEP 4:
WIRING:
If applicable, insert supply wires into supplied
ballast quick connect. Proceed to step 5.
Take note of the color of the wire(s) on your fixture. Identify
which group your fixture wire(s) falls into and connect the wires
according to the directions below:
B. Take your fixture wire(s) from group A and place evenly against
the black wire from the outlet box.
DO NO
T
twist wires together
before using wire connectors.
C. Fit a wire connector (not supplied) over the wires and thread the
connector clockwise until you feel a firm resistance.
D. Gently try to remove the wires from the connector. If you can
remove the wires, carefully re-do steps B and C, as above and
check again for a firm connection.
E. Connect the fixture wire from group B to the white wire from the
outlet box in the same manner.
IF SUPPLY WIRES ARE LOCATED WITHIN
3" OF BALLAST, USE WIRE RATED FOR
AT LEAST 90°C
STEP 1:
STEP 2:
STEP 3:
Determine exact location on ceiling for fixture placement.
Feed the black and white ballast wires through the 7/8” wire exit hole
of the fixture pan (A).
Mount fixture to ceiling. When mounting to drywall use molly bolts.
When mounting to ceiling joists use 1 1/4" screws.
FINAL ASSEMBLY
STEP 2:
STEP 3:
Secure diffuser (D) by placing one edge of diffuser (D) over one lip
of fixture pan (A) so clips on diffuser lock to fixture pan (A). Repeat
with other side of diffuser (D).
NOTE: IN ORDER FOR THIS LIGHTING FIXTURE TO OPERATE
PROPERLY, THE BUILDING’S ELECTRICAL SYSTEM MUST BE
GROUNDED. IF YOU ARE UNCLEAR AS HOW TO PROCEED,
CONSULT A QUALIFIED ELECTRICIAN.
Install lamps.
STEP 1:
Install center cover (B) over fixture by squeezing center cover (B)
together and insert under tabs (C).
Make sure no bare wires can be seen outside wire connectors.
STEP 5:
GROUNDING INSTRUCTIONS: The green grounding screw is to
be inserted into the hole with two raised dimples provided on the
fixture pan. Wrap the ground wire from the fixture (if supplied) and the
ground wire from the outlet box (bare metal or green insulated
wire) around the green grounding screw on the fixture pan. If
uninsulated wire is on the chassis, connect the ground wire from
the fixture (if supplied) and the outlet box to it using a small wire
connector (not supplied).
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.
CLEANING
To clean, wipe fixture body with a soft cloth. Clean glass with a mild
soap. Do not use abrasive materials such as scouring pads or
powders, steel wool, or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
Hg
MARK MEANS LAMP CONTAINS MERCURY.
FOLLOW DISPOSAL
LA
WS.
SEE WWW
.LAMPRECYCLE.ORG