Installation Guide

ManualsBrandsSea Gull Lighting ManualsOutdoor Pendant Lights6008-12

FOR YOUR SAFETY

ASSEMBLY

ENERAL

ARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

teps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully.

If you are unclear as to how to proceed,

consult a qualified electrician.

arefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1, 2 & 3. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

*OUTLET BOX

*WIRE

CONNECTORS

CANOPY (G)

NIPPLE (C)

TOP ASSEMBLY (K)

NUT (B )

LOCKWASHER (Q)

CANOPY (H)

MOUNTING

SCREWS (I)

CAP NUTS (F)

STEP 1:

STEP 3:

STEP 2:

NOTE: Top assembly may be factory installed. Place top assembly

(P) on fixture cage (O) and secure in place with cage screws (T).

Install small loop (E) on canopy (G) with lockwasher (Q) and nut (B).

(Note: Loop may be factory installed.).

Install large loop (J) on nipple (C).

GREEN

GROUNDING SCREW (D)

*OUTLET BOX

SCREWS

MOUNTING

BAR (A)

*WIRE

CONNECTORS

MOUNTING

SCREWS (I)

*GROUND WIRE

*OUTLET BOX

GROUNDING AND MOUNTING BAR LOCK UP

FOR FLUSH MOUNT

FIGURE 2

FIGURE 3

FIGURE 1*NOT SUPPLIED

*NOT INCLUDED

FOR CHAIN HUNG (FIG. 1)

COUPLING (M)

FOR CHAIN HUNG

CAP

NUTS (F)

SMALL LOOP (E)

CHAIN (N)

LARGE

LOOP

(J)

TOP

ASSEMBL

(K)

CAGE

SCREWS (P)

CAGE (R)

NIPPLE (C)

CAUTION:

Fixtures with photo-cells should be mounted at least 48”

from all sides to avoid reflection of light back onto Photo-cell,

causing the Photo-cell to malfunction or flicker.

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-320

52810

Summary of content (2 pages)

PAGE 1
HC-320 Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ FOR YOUR SAFETY 052810 ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF .
PAGE 2
ASSEMBLY CONT. HC-320 STEP 2: FOR FLUSH MOUNT (IF APPLICABLE) (FIG. 3) Insert top assembly (K) through canopy (H). Secure in place with lock washer (Q) and nut (B) D. Try gently to pull the connector off the wires. If you can pull the connector off, carefully re-do steps B and C, as above and check again for a firm connection. E. Connect the fixture wire from group B to the white wire from the outlet box in the same manner. STEP 6: INSTALLATION IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX.