Installation Guide

1A
Install the Fixture
ELECTRICAL BOX
MOUNTING PLATE
MOUNTING PLATE SCREW
CANOPY
THREADED NIPPLE
SCREW COLLAR
COLLAR NUT
LAMP
1
CHAIN
3
2
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate and the screw collar onto
the threaded nipple.
Secure the mounting plate to the electrical box with two mounting plate screws.
Weave the cord through the shade, then insert the socket assembly into the shade and secure it by screwing the
fixture loop onto the socket assembly.
Determine the wanted height of the fixture and remove a portion of the chain by opening a link and removing it
from the bottom.
Unscrew the collar nut from the screw collar, then install the canopy and collar nut onto the chain (in that order).
Install the open link onto the fixture loop and secure it in place by closing the link.
Weave the cord through the chain, screw collar, canopy, threaded nipple, and out of the electrical box. Trim the cord
leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place by screwing
the collar nut tightly onto the screw collar.
Screw the lamp into the socket.
1
2
3
4
5
6
7
8
9
10
11
12
FIXTURE LOOP
SOCKET ASSEMBLY
13
2 2
3
SHADE
Use 120 voltMAX 100 Watt
Type A19 Medium Base Lamp.