Installation Guide

Installation Instructions for

Oglesby Flush Mount

1.0

990C7501903-OGB

7501903

CEILING

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations.

Incandescent version may be dimmed with a standard incandescent

dimmer. version may be dimmed with a dimmer. ConsultLED LED

lamp manufacturer for additional information.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

7400 Linder Ave, Skokie, 160077IL

800.969.3347

www.generationlighting.com

The "Generation Lighting" graphic is a registered trademark of

Generation Lighting. Generation Lighting reserves the right to

change specifications for product improvements without notification.

SAVETHESE INSTRUCTIONS!

PAGE 1
Installation Instructions for 990C7501903-OGB Oglesby Flush Mount CEILING 7501903 1.0 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. Use minimum 90°c supply conductors. GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations.
PAGE 2
Install the Fixture 1A JUNCTION BOX 5 6 FIXTURE BASE MOUNTING STUD FIXTURE BASE MOUNTING PLATE 3 CAP NUT 7 3 3 3 HOOK LOOP LAMP STRAND 1 Secure the mounting plate to the junction box. 2 Screw the lamps to the sockets. Refer to the label on the socket for max wattage information. 3 Install the strands by pinching the hooks at the ends of the strands, then inserting them into the fixture base, and releasing them to secure in place.