Installation Guide

2
1A
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the junction box with two mounting plate screws.
Install the decorative cover by placing it on top of the fixture.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the fixture onto the threaded nipple, and slightly tighten the
cap nut onto the threaded nipple.
Screw the lamps into the sockets.
Temporarily raise the decorative cover, install the crystals by hanging them as shown, and lower the decorative cover
back onto the fixture.
Fully secure the fixture by completely screwing the cap nut onto the threaded nipple.
1
2
3
4
5
6
Install the Fixture
Use 120 voltMAX 100 Watt
Type A19 Medium Base Lamp.
7
8
9
LAMP
CRYSTAL
JUNCTION BOX
NEUTRAL WIRE
WHITE WIRE
HOT WIRE
BLACK WIRE
MOUNTING PLATE SCREW
MOUNTING PLATE
5
9
6
2
THREADED NIPPLE
FIXTURE
MOUNTING PLATE STUD
CAP NUT
8
DECORATIVE COVER
10
2
3
9
1