Installation Guide

ManualsBrandsSea Gull Lighting ManualsLightingOutdoor Ceiling White 2-Light Outdoor Flush Mount with LED Bulbs

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-332

81108

Carefully remove the fixture from the carton and check that all parts

are included, as shown in figure 1. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

•

Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

and create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified

electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Read instructions carefully.

• For fixtures provided with 75° C or 90° C supply wire warning only

(these warnings are provided on the label and on the fixture carton).

Risk of fire. Most dwellings built before 1985 have supply wire rated

60°C. Consult a qualified electrician befor

installing.

• Save these instructions.

IMPORTANT SAFETY INSTRUCTIONS

BEFORE YOU BEGIN

To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.

Do not use abrasive materials such as scouring pads or powders,

steel wool or abrasive paper.

Keep this sheet for future reference, and in case you need to order

replacement parts. Parts for this fixture can be ordered from place of

purchase. Be sure to use exact wording from illustration when

ordering parts.

CLEANING

ORDERING PARTS

IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX.

INSTALLATION

IF SUPPLY WIRES ARE LOCATED WITHIN 3” OF BALLAST, USE WIRE

RATED FOR AT LEAST 90°C.

FIGURE 1 *NOT SUPPLIED

Secur

e mounting bar (A) to outlet box with outlet box scr

ews (not

supplied). Thr

ead nut (B) on nipple (C) so that 3 threads ar

e exposed

above nut (B). Thread nipple (C) into mounting bar (A) and secure

with nut (B).

STEP 1:

GREEN

GROUNDING

SCREW (D)

*OUTLET BOX

MOUNTING

BAR (A)

LOCKWASHER

AND NUT (B)

NIPPLE (C)

*GROUND

WIRE

*OUTLET

BOX

SCREWS

*WIRE

CONNECTORS

FIXTURE

PAN (G)

CAP NUT (H)

CAGE (F)

DIFFUSER

PANELS (E)

FIXTURE

MOUNTING

SCREWS

(J)

Summary of content (2 pages)

PAGE 1
Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ HC-332 081108 IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off.
PAGE 2
INSTALLATION (continued) HC-332 FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors. STEP 2: A. Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below: STEP 4: After wires are connected, tuck them carefully inside outlet box and then raise the fixture pan (G) against ceiling and secure with cap nut (H).