Installation Guide

ManualsBrandsSea Gull Lighting ManualsFlush Mount LightingSfera 13.5-in Autumn Bronze Modern/Contemporary Flush Mount Light ENERGY STAR

Install the Fixture

ELECTRICAL BOX

MOUNTING PLATE SCREW

CANOPY

COLLAR NUT

FIXTURE LOOP

CHAIN

SCREW COLLAR

THREADED NIPPLE

MOUNTING PLATE

SHADE

SOCKET

FINIAL

SHORT THREADED NIPPLE

DECORATIVE CUP

FRAME

BALL NUT

HEX NUT

Semi-Flush Mounting

MOUNTING

PLATE

MOUNTING PLATE STUD

BALL

NUT

LOWER

CANOPY

FOR SEMI FLUSH MOUNT ONLY-:Install the mounting plate with the two mounting studs to the electrical box with two mounting plate screws.

SKIP TO STEP 9

If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate and the screw collar onto the threaded nipple.

Secure the mounting plate to the electrical box with two mounting plate screws.

Determine the wanted height of the fixture and remove a portion of the chain by opening a link with pliers.

Screw the fixture loop onto the lower canopy assembly. Open the chain link with pliers and install the chain on the fixture loop, then re-close the

chain link.

Unscrew the collar nut from the screw collar, install the collar nut and the canopy onto the chain (in that order).

Open a link on the other end of the chain with pliers and install the chain onto the screw collar to secure the fixture, re-close the link.

Weave the cord through the lower canopy assembly, chain, collar nut, screw collar, canopy, threaded nipple, and out of the electrical box. Trim the

cord leaving enough to make electrical connections.

Connect the fixture to a suitable ground in accordance to local electrical codes.

Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.

Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.

FOR SEMI FLUSH MOUNT ONLY SKIP TO STEP-:Align then place the canopy onto the mounting plate studs and secure it with the two ball nuts.

Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place by screwing the collar nut tightly onto

the screw collar.

Screw the lamps into the sockets. Refer to the label in the socket for Max Wattage Information.

Place the shade into the frame, insert the short threaded nipple through the shade and frame, and secure them using the hex nut.

Install the frame to the fixture using the ball nuts.

Install the decorative cup onto the short threaded nipple and secure it in place by tightening the finial.

LOWER CANOPY

BALL NUT

BOLT