Installation Guide

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF.

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully. If you are unclear as to how to proceed,

consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

fixture.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

STEP 1:

BRACKETS (G)

FITTER (M)

DIFFUSER (B)

WARNING

NOTE: DO NOT INSTALL ON A POST OR A POLE

THAT RESULTS IN A VERTICAL RISE OF 25 FEET

OR HIGHER.

*POST

*NOT SUPPLIED FIG. 1

RETAINING

SCREWS (X)

NOTE: This glass is handcrafted, the slight

imperfections in the glass add to the

authenticity of the fixture.

Installation And

Safety Instruction

HC-534

092001

Line art shown may not exactly match the fixture enclosed.

However, the installation instructions do apply to this fixture.

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS FOR YOUR SAFETY ASSEMBLY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF. GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully.
PAGE 2
INSTALLATION HC-534 STEP 2: GROUNDING INSTRUCTIONS: Connect the ground wire from the fixture (bare metal or green insulated wire) to the ground wire from the power supply (bare metal or green insulated wire) using a small wire connector (not supplied). NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES. STEP 3: Slide fitter (M) onto post. Secure in place with screws (not supplied).