Installation Guide

FOR YOUR SAFETY
ASSEMBLY
GENERAL
W
ARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF.
You don’t need special tools to install this fixture. Be sure to follow the
steps in the order given. Under no circumstances should a fixture be
hung on house electrical wires, nor should a swag type fixture be
installed on a ceiling which contains a radiant type heating system.
Read instructions carefully.
If you are unclear as to how to proceed,
consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this
fixture.
C
arefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1 & 2. Be careful not to misplace
a
ny of the screws or parts which are needed to install this fixture.
STEP 1:
I
nsert glass into cage (if applicable).
STEP 2:
GROUNDING
MOUNTING BAR
FLAT STRAP (B)
MOUNTING BAR
OFFSET STRAP (C)
GROUNDING WIRE
*OUTLET BOX
SCREWS (K)
GREEN
GROUNDING SCREW (L)
FIXTURE
MOUNTING
SCREWS (I)
*WIRE
CONNECTOR
FIGURE 2
*NOT SUPPLIED
NOTE: This glass is handcrafted, the slight imperfections in
the glass add to the authenticity of the fixture.
WARNING: TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR PERSONAL INJURY,
MOUNT TO OUTLET BOX OR SUPPORTING
SYSTEM ABLE TO SUPPORT THE
WEIGHT OF THE FIXTURE.
*NOT SUPPLIED
FIGURE 1
CAGE
(F)
GLASS
(P)
*OUTLET
BOX
FIXTURE MOUNTING SCREWS (I)
RET
AINING
SCREWS
(R)
MOUNTING
BAR FLAT
STRAP (B)
MOUNTING
BAR OFFSET
STRAP (C)
*WIRE
CONNECTORS
Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
HC-640
0
82103