Installation Guide

ManualsBrandsSea Gull Lighting ManualsOutdoorsChatham 1-Light Outdoor Oxidized Bronze Wall Mount Fixture

INSTALLATION AND SAFETY INSTRUCTIONS

*OUTLET BOX

FIGURE 1 *NOT INCLUDED

CROSS MOUNTING

BAR (B)

CAGE

MOUNTING

SCREWS (I)

GREEN

GROUNDING

SCREW (G)

GROUND

WIRE

*NOT SUPPLIED

FIGURE 2

GROUNDING & CROSS

MOUNTING BAR LOCK UP

Installation And Safety

Instruction

HC-1331

013008

Line art shown may not exactly match the fixture enclosed.

However

, the installation instructions do apply to this fixture.

Fill In Item Number On Carton And

ile

This Sheet For Fixture Reference. ITEM#_________

NOTE: This glass is handcrafted, the slight imperfections

in the glass add to the authenticity of the fixture.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figures 1 & 2. Be careful not to misplace

ny of the screws or parts which are needed to install this fixture.

• Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

•

Use of other manufacturers components will void warranty, listing

and create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• Proper wiring is essential for the safe operation of this fixture.

•

To reduce the risk of electrical shock, provide a watertight seal between

the fixture and the mounting surface by using a silicone or similar caulking.

•

Save these instructions.

IMPORTANT SAFETY INSTRUCTIONS

*OUTLET BOX SCREWS

BACK

PLATE (M)

BEFORE YOU BEGIN

CAP

NUTS

(N)

MOUNTING BAR

FLAT STRAP (B)

MOUNTING

BAR OFFSET

STRAP (C)

GROUNDING WIRE

*OUTLET BOX

SCREWS (K)

GREEN

GROUNDING SCREW (G)

FIXTURE

MOUNTING

SCREWS (I)

*WIRE

CONNECTOR

MOUNTING BAR

OFFSET STRAP (C)

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • BEFORE YOU BEGIN Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off. Use of other manufacturers components will void warranty, listing and create a potential safety hazard. If you are unclear as to how to proceed, contact a qualified electrician. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given.
PAGE 2
HC-1331 INSTALLATION IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Insert fixture mounting screws (I) in threaded holes of mounting bar offset strap (C). Run fixture mounting screws (I) all the way down to their heads. STEP 2: Place mounting bar offset strap (C) against outlet box (not supplied) and secure in place using outlet box screws (not supplied). Be sure the mounting screws (I) are perfectly horizontal so fixture hangs straight.