Installation Guide

Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
HC-231
FIGURE 1
*NOT INCLUDED
• Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
• Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
• If you are unclear as to how to proceed, contact a qualified electrician.
• You don’t need special tools to install this fixture.
•
Be sure to follow the steps in the order given.
•
Proper wiring is essential for the safe operation of this fixture.
• To reduce the risk of fire, electric shock or personal injury, mount to
outlet box or supporting system able to support the weight of the
fixture.
•
Read instructions carefully.
• Save these instructions.
IMPORTANT SAFETY INSTRUCTIONS
BEFORE YOU BEGIN
NOTE: This glass is handcrafted, the slight imperfections in the
glass add to the authenticity of the fixture.
0
61909
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
p
urchase. Be sure to use exact wording from illustration when
ordering parts.
T
o clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
CLEANING
ORDERING PARTS
NOTE: FOR FIXTURES LABELED FOR WET LOCATION AND
USED OUTDOORS.
CAUTION:
To reduce the risk of electrical shock, provide a watertight
seal between the fixture and the mounting surface by using a silicone
or similar caulking.
WET LOCATION
Fixtures with photo-cells should be mounted at least 48" from all
sides to avoid reflection of light back onto Photo-cell, causing the
Photo-cell to malfunction or flicker.
*OUTLET BOX
*SUPPLY
GROUND
WIRE
UNIVERSAL
MOUNTING
PLATE (B)
FIXTURE
MOUNTING
SCREWS (A)
GREEN
GROUNDING
SCREW (C)
*#8-32 OUTLET BOX SCREWS
BACK
PLA
TE
(D)
CAP NUTS (E)
*ORANGE
WIRE
CONNECTOR
Place end of scroll (G) into loop (F).
STEP 3:
Carefully remove the fixture from the carton and check that all parts
are included, as shown in Figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
STEP 1:
(If applicable) Thread loop (F) to top of fixture. Thread supplied #8-32
screw through scroll (G) and backplate (D). Thread supplied hex nut
onto back plate side of #8-32 screw to secure scroll (G) to backplate
(D).
STEP 2:
SCROLL (G)
LOOP (F)