Installation Guide

NOTE: This glass is handcrafted, the slight imperfections in the

glass add to the authenticity of the fixture.

arefully remove the fixture from the carton and check that all parts

are included, as shown in figure 1 and 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

*OUTLET

BOX

*NOT INCLUDEDFIGURE 1

UNIVERSAL

MOUNTING

BAR (J)

*WIRE CONNECTOR

BACKPLATE (A)

• Be sure the electricity to the system you are working on is turned

off; either the fuse removed or the circuit breaker set at off.

• Use of other manufacturers components will void warranty, listing

nd create a potential safety hazard.

• If you are unclear as to how to proceed, contact a qualified

electrician.

• You don’t need special tools to install this fixture.

• Be sure to follow the steps in the order given.

• To reduce the risk of fire, electric shock or personal injury, mount to

utlet box or supporting system able to support the weight of the

fixture.

• Read instructions carefully.

•

Save these instructions.

IMPORTANT SAFETY INSTRUCTIONS

CAP NUTS (H)

BEFORE YOU BEGIN

Installation And Safety Instructions

Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to

this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________

HC-1383

43012

GREEN

GROUNDING

SCREW (L)

FIXTURE

MOUNTING

SCREWS

(I)

*OUTLET

BOX

SCREWS

PAGE 1
Installation And Safety Instructions Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________ IMPORTANT SAFETY INSTRUCTIONS • • • • • • • • HC-1383 043012 BEFORE YOU BEGIN Be sure the electricity to the system you are working on is turned off; either the fuse removed or the circuit breaker set at off.
PAGE 2
INSTALLATION HC-1383 IMPORTANT: DO NOT ATTACH FIXTURE DIRECTLY TO OUTLET BOX. STEP 1: Insert fixture mounting screws (I) in threaded holes of universal mounting bar (J). Run screws all the way down to the heads. STEP 4: GROUNDING INSTRUCTIONS: Connect the supply ground wire, fixture ground wire using UL approved wire nuts. Gently try to remove the wires from the connector. If you can remove the wires, carefully redo the wiring connection. NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES.