Installation Guide

1
. Make trench for stake (O) and cable in the ground.
2. Thread in-ground stake (O) into surface mount base (N).
S
ecure in-ground stake (O) and surface mount base (N)
using screws (See Figure 5).
3. Run cable through surface mount base (N) and stake (O)
and thread surface mount base (N) to nipple (I) tightly.
4
. Connect low voltage wires to supply cable using silicone
wire nuts (not supplied) or other UL listed device.
5. Insert stake (O) into trench and tamp ground around stake
(O) to secure in place.
*SCREWS (M)
SURFACE MOUNT
BASE (N)
IN-GROUND
STAKE (O)
1. Slip fixture wire through surface mount base (N).
2. Thread fixture to surface mount base (N).
3. Position surface mount base (N) on desired surface. Secure
with three screws (M).
4. Connect fixture wire to supply wire using silicone wire nuts
(not supplied) or other UL listed device.
To use optional Lens...
Remove spring attachment from gasket and insert lens or
louver into gasket. Secure in place with spring attachment.
*NOT SUPPLIED
FIGURE 4
*NOT SUPPLIED
FIGURE 5
I
N GROUND INSTALLATION (Figure 4) HC-558
SURFACE MOUNT INSTALLATION (Figure 5)