Installation Guide

2
Using a 2-3/8” hole saw, cut a hole into the ceiling at
the desired location(s).
Bring the low-voltage wires to the ceiling cut-out.
*For class 2 installations, use Type C 2 cable.L
*For non-class 2 installations, use non-metallic sheathed
cable, Type NM.
3
Install the Fixture
4
1
NOTE: Follow the transformer instructions to install, properly
connect, and bring low-voltage wire leads to the fixture’s
mounting location.
2
1A
2-3/8”
2
1B
From the top of the fixture, remove one of the screws,
loosen the other, and swing the top cover open.
Strip a 1/4” of insulation from each low-voltage wire
and connect the low-voltage wires to adjacent terminals
on either the right or left side of the terminal block.
If powering multiple fixtures, use the additional ports to
connect to the next fixture.
Make sure not to pinch the wires and re install the top
cover (reversal of step 3). The plastic insert serves to
provide strain relief for the input wires.
LOW-VOLTAGE
WIRES
TOP COVER
SCREW
5
6
3
3
3
TOP
COVER
4
4
5
5
Rotate the spring retainers completely up and insert the
fixture into ceiling until it is securely in place.
7
SPRING
RETAINER
CEILING
1C
NOTE: This instruction covers round and square versions.
Round version was used for illustration purposes.
NOTE: For square versions, ensure that the fixture is parallel or
perpendicular to the walls, this will ensure that the fixture is
oriented to the room.