Installation Guide

ManualsBrandsSea Gull ManualsOutdoor Wall LightsClassico 25.5-in H Black Medium Base (E-26) Outdoor Wall Light

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Read instructions carefully.

If you are unclear

as to how to proceed, consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this

fixture.

NOTE FOR FIXTURES THAT ARE SOLID BRASS:

Your handcrafted, solid brass lighting fixture has been coated

with a durable, baked on acrylic lacquer which gives maximum

protection against the weather. In time, however, the brightness

of the brass will tarnish giving way to an authentic old world

brass finish.

NOTE: To keep your solid polished brass fixture looking new

for years to come, regularly apply a good quality non-abrasive

car wax to all metal surfaces, giving the fixture an extra

protective coating.

(FIG. 1)

GROUNDING & UNIVERSAL MOUNTING

BAR LOCK UP (FIG. 2)

*NOT SUPPLIED

TOP ASSEMBLY (O)

TOP ASSEMBLY

SCREWS (Q)

*OUTLET BOX

CAGE (P)

CAGE SCREWS (S)

TOP PLATE (R)

CAP NUTS (N)

ROUND NUT (H)

COUPLING (D)

BACKPLATE (M)

CENTER PIPE (C)

TAIL (E)

BREAK A

*OUTLET BOX

SCREWS (K)

GREEN

GROUNDING

SCREW (L)

BREAK A

BREAK B

FINIAL (F)

MOUNTING

SCREWS (I)

*WIRE CONNECTOR

UNIVERSAL

MOUNTING

BAR (J)

WITHOUT TAIL

ASSEMBLY (FIG. 3)

PIPE (G)

ROUND NUT (H)

FINIAL (F)

NOTE: This glass is handcrafted, the slight imperfections in the

glass add to the authenticity of the fixture.

Installation And

Safety Instruction

HC-224

011005

Line art shown may not exactly match the fixture enclosed.

However, the installation instructions do apply to this fixture.

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

Summary of content (2 pages)

PAGE 1
INSTALLATION AND SAFETY INSTRUCTIONS NOTE FOR FIXTURES THAT ARE SOLID BRASS: FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF . GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician. NOTE: Proper wiring is essential for the safe operation of this fixture.
PAGE 2
ASSEMBLY HC-224 STEP 1: Carefully remove the fixture from the carton and check that all parts are included, as shown in Figure 1, 2 & 3. Be careful not to misplace any of the screws or parts which are needed to install this fixture. STEP 2: NOTE: If fixture is supplied with tail unassembled, follow steps A & B below. Some fixtures may not have a tail assembly. If not, proceed to installation instructions. A. Screw center pipe (C) of tail into coupling (D) at the bottom of the fixture. B.