Installation manual

Installation 6012-33 Installation Manual
3-9
5. Extract the locking bar from the underside of
the cross-level beam and retain these parts for
later re-use if it becomes necessary to stow
the antenna.
6. Verify that the antenna rotates (tilts left and
right from level) freely through its full cross-
level range of motion.
3.6. Installing the Below Decks Equipment.
3.6.1. General Cautions & Warnings
CAUTION - Electrical Shock Potentials exist on the Gyro Compass output
lines. Assure that the Gyro Compass output is turned OFF when handling and
connecting wiring to the MXP.
CAUTION - Allow only an authorized dealer to install or service the Sea Tel
System components. Unauthorized installation or service can be dangerous and may
invalidate the warranty.
3.7. Connecting the Below Decks Equipment
Connect this equipment as shown in the System Block Diagram. Install the equipment in a standard 19 inch
equipment rack or other suitable location. Optional slide rails are available.
3.7.1. Connecting the ADE AC Power Cable
Connect the AC Power cable that supplies power to the ADE to a suitably rated breaker or UPS.
3.7.2. Connecting the BDE AC Power Cables
Connect the AC Power cables that supply power to the Below Decks Equipment (MXP, Satellite Modem,
phone, fax, computer and all other equipment) to an outlet strip fed from a suitably rated breaker or UPS.
3.7.3. Media Xchange Point™ (MXP) Connections