Installation manual

Setup – Blockage & RF Radiation Hazard Zones 6012-33 Installation Manual
10-3
2. Enter a readily identifiable name for the
zone (ie Mast, Deck House or Stack).
3. Moving to the right, enter the relative of
the starting point of this blockage zone
(the more counter-clockwise bearing).
4. Then enter the relative bearing of the stop
point of this blockage zone (the more
clockwise of the two bearings).
5. Likewise, for Elevation, you need only to
enter the elevation angle, below which you
want the transmitter inhibited (blocked).
6. Repeat steps 2-5 to describe up to 4
blockage zones.