System information

Maintenance Coastal 24 & 30 Ku-Band TVRO
6-16
17 If the Pot was NOT replaced skip to step
22.
18 If the pot WAS replaced, hold the
sprockets in alignment and use a flat
blade screwdriver to rotate the shaft of the
Pot to one end stop of the Pot. The Pot is
has a 3 turn range from one stop to the
other. From one stop, rotate the shaft 1
½ turns to center of the Pots’ range. This
sets the center of the pot to be in-line with
the center of the mechanical range of
rotation of the large sprocket.
19 Check the alignment of the belt travel (Pot
sprocket should be all the way down on
the Pot shaft).
20 Tighten the 2 set screws in the Pot
sprocket.
21 Rotate the large sprocket full CW. The
timing mark on the pot sprocket should be
inside the left side of the belt as shown.