System information

DAC-2202 Antenna Control Unit Operation
2-7
In DVB Mode
Baud 20000 AGC 1234
In SCPC Mode
KHz 0999 AGC 1234
Press DOWN or ENTER to access the Sat ID Receiver Baud entry mode.
This is used to input the numeric value of Baud Rate (symbol rate) OR of
the KHz value of the desired the Intermediate Frequency (950-2150) you
want to use for Tracking. This setting of the Satellite Identification tracking
receiver and the current signal level (AGC) will be displayed.
In DVB Mode: BAUD 20000 AGC 1234
In SCPC Mode: KHz #### AGC 1234
To manually update, press the LEFT or RIGHT arrow key to bring the cursor
up under the character to the left, or right, of the decimal point
respectively. Continue to move the cursor until the desired character to be
edited is underscored (selected). Use the UP or DOWN arrow keys to
increment or decrement the selected character.
DVB: Current receivers can be set to any desired Baud Rate between 3000
and 30000. It should be set to the symbol/baud rate of the digital carrier
you chose to use for tracking. This setting also changes the bandwidth of
the receiver. Baud setting of 3000-5000 sets the receiver to 15 MHz
bandwidth. 6000-30000 sets the receiver bandwidth to 30MHz.
SCPC: Key in the desired KHz frequency value you wish to use for
tracking.
Press ENTER to set the desired Baud/KHz and return to the Baud/KHz
display OR Press NEXT to abort and return to the main Satellite display.
Tone OFF AGC 1234
Press DOWN or ENTER to access the Tone sub-menu. This setting is
used to turn ON or OFF a continuous 22 KHz Tone output from the tracking
receiver.
Press the LEFT or RIGHT arrow key to display a cursor underneath the
current state. Use the UP or DOWN arrow key to change states.
ON is used to select High Band frequencies and OFF is used to select Low
Band frequencies from the matrix switch.
Press ENTER to set the desired tone setting OR Press NEXT to abort and
return to the main Satellite display.
Volt HORZ AGC 1234
Press DOWN or ENTER to access the Volt sub-menu. This setting is
used to select the Voltage output from the tracking receiver, based on the
desired received transponder polarity. Available selections are; HORZ
(18VDC), LHCP (18VDC), VERT (13VDC) or RHCP (13VDC).
To change selection, press the LEFT or RIGHT arrow key to display a
cursor underneath the current selection. Use the UP or DOWN arrow key
to scroll through the selections.
Press ENTER to set the desired Voltage setting OR Press NEXT to abort
and return to the main Satellite display.