System information

DAC-2202 Antenna Control Unit Setup
5-11
Use the LEFT or RIGHT arrow key to move the cursor left or right to select other characters to modify.
When you are finished modifying press ENTER to execute the new value OR press NEXT to abort and
exit setup mode.
5.22. TRACK DISP
This parameter set the selections that the user will see in the Tracking - Band Selection menu. Band
Selection must be set to the appropriate selection for Tracking to operate properly.
Band selection controls the local logic output state of SW1 output terminal on the Terminal Mounting
Strip PCB and remote C/Ku relays (or other switches) on the antenna pedestal.
The displayed selections and SW1 status are listed in the following table:
Setting Displayed selection Tone/Band/Voltage Status SW1 Status
0000 C
X
KuLo
KuHi
Tone OFF, Band 0, 13V
Tone ON, Band 0, 13V
Tone OFF, Band 1, 13V
Tone ON, Band 1, 13V
Open
Short
Open
Short
0020 CNV1A
CNV1B
CNV2A
CNV2B
Tone OFF, Band 0 , 13V
Tone ON, Band 0, 13V
Tone OFF, Band 1, 13V
Tone ON, Band 1, 13V
Open
Short
Open
Short
0040 CoPol
CoPol
X Pol
X Pol
Tone OFF, Band 0 , 13V
Tone ON, Band 0, 13V
Tone OFF, Band 1, 13V
Tone ON, Band 1, 13V
Open
Short
Open
Short
0100 PAOFF
PAOFF
PA ON
PA ON
Tone OFF, Band 0 , 13V
Tone ON, Band 0, 13V
Tone OFF, Band 1, 13V
Tone ON, Band 1, 13V
Open
Short
Open
Short
0110 PA ON
PA ON
PAOFF
PAOFF
Tone OFF, Band 0 , 13V
Tone ON, Band 0, 13V
Tone OFF, Band 1, 13V
Tone ON, Band 1, 13V
Open
Short
Open
Short
0130 Xp Lo
XpMid
Xp Hi
RxOff
Tone OFF, Band 0, 13V
Tone ON, Band 0, 13V
Tone OFF, Band 0, 18V
Tone ON, Band 0, 18V
Open
Short
Open
Short
0150 Co Lo
CoMid
Co Hi
RxOff
Tone OFF, Band 1 , 13V
Tone ON, Band 1, 13V
Tone OFF, Band 1, 18V
Tone ON, Band 1, 18V
Open
Short
Open
Short
0170 Xp B1
Xp B2
Xp B3
Xp B4
Tone OFF, Band 0 , 13V
Tone ON, Band 0, 13V
Tone OFF, Band 0, 18V
Tone ON, Band 0, 18V
Open
Short
Open
Short