System information

DAC-2202 Antenna Control Unit Maintenance & Troubleshooting
7-21
10
This drop-down list box presents the Gyro Type parameter value currently stored in Flash. To
change to Gyro type, mouse click on the selection arrow and choose the desired gyro source
which is interfaced with the DAC2202.
11
Click the SUBMIT button to transfer all currently displayed parameters to the 68HC08 module
operating software variables table. NOTE: The submit button will not store the values to flash, an
ACU reset (hard or soft) will revert to the old settings.
7.9.4. DAC Parameters Page 2
Number Description
1
Click to redirect to the Port Settings Page. This page presents the TCP connection and baud rate
settings for the Comm If Module.
2
Click to redirect to the DAC Parameters 1 Page. This page presents the current ACU
configuration parameter values stored in the 68HC08 processor.
3
Click to redirect to the DAC Parameters 2 Page. This page presents the current Satellite Tracking
parameter values stored in the 68HC08 processor. This page also contains the currently defined
blockage zones (Az Limits 1-6).
4
Click to redirect to the Status page. This page presents current system status, including Tracking
condition, Antenna Position, Vessel Location / Orientation, and decoded error conditions.
5
Click to redirect to the Home page. This page presents current system software versions and
antenna model configuration.
6
Click the RELOAD button to refresh the screen to display the current ACU parameter values
7
Click the SAVE button to store all currently displayed parameters to Flash (68HC08).