System information

DAC-2202 Antenna Control Unit Maintenance & Troubleshooting
7-23
7.9.5. Status Page
Number Description
1
These fields presents the current antenna status.
2
Click to redirect to the Port Settings Page. This page presents the TCP connection and baud rate
settings for the Comm If Module.
3
Click to redirect to the DAC Parameters 1 Page. This page presents the current ACU
configuration parameter values stored in the 68HC08 processor.
4
Click to redirect to the DAC Parameters 2 Page. This page presents the current Satellite Tracking
parameter values stored in the 68HC08 processor. This page also contains the currently defined
blockage zones (Az Limits 1-6).
5
Click to redirect to the Status page. This page presents current system status, including Tracking
condition, Antenna Position, Vessel Location / Orientation, and decoded error conditions.
6
Click to redirect to the Home page. This page presents current system software versions and
antenna model configuration.
7
The Refresh field allows the user to adjust the page refresh settings, AUTO is selected by default,
which refreshes the displayed page every 5 seconds
8
These fields presents the antenna’s positional and signal strength information currently stored.
To change a parameter value mouse click inside the entry field and type in the desired value
Refer to Setup (Section 5) of this manual for acceptable range values.
9
The Control field buttons allow the user to Toggle the antennas’ current tracking condition or to
clear any reported errors as reported in fields 10 and 11.
10
The ACU Errors box is a read only field that presents the decoded ACU reported errors that are
currently triggered. Refer to the Maintenance section of this manual for troubleshooting frequent
or constant errors.
11
The PCU Errors box is a read only field that presents Pedestal reported errors currently triggered.
Refer to the Maintenance section of this manual for troubleshooting frequent or constant errors.