Manualshelf

Installation manual

ManualsBrandsSea Tel ManualsConsumer electronicsDAC-2302
31323334353637383940
Setup – Band Selection 6009-33 Installation Manual
6-1
6. Setup – Band Selection
To properly control the band selection of the LNB(s) mounted on the antenna the TRACK DISP (Tracking Display) parameter
must be set correctly. Which value the TRACK DISP parameter is set to depends on the hardware configuration of the antenna
pedestal.
The xx09-17 and xx09-33 antenna pedestals come with the waveguide diplexer and LNB to provide the additional Co-Pol RXIF
output to the Cross-Pol/Co-Pol select coax switch (all of the systems come with the switch and coax installed, so you can easily
upgrade the antenna with the Co-Pol hardware).
The TRACK DISP parameter controls Tone, Voltage and Aux functions remotely on the antenna pedestal. Voltage and Tone are
used to select the desired band of dual-band, tri-band and quad-band LNBs. The Aux function controls the Cross-Pol/Co-Pol
select switch.
Sea Tel provides quad-band LNBs as a default LNBs on the 09 Series antennas, therefore, the default TRACK DISP parameter for
Cross-Pol only systems is 0170 and 0130 for 09 antennas with Cross-Pol AND Co-Pol LNBs.
6.1. Cross-Pol AND Co-Pol Quad-Band LNBs
This is the default setting for the Series 09 antenna pedestals with Quad-Band SMW LNBs.
Use the Xp B1 when you want Cross-Pol Band1 output to be routed to below decks, Xp B2 selects Cross-Pol Band2, Xp
B3 selects Cross-Pol Band3 and Xp B4 selects Cross-Pol Band4. Use the Cp B1 when you want Co-Pol Band1 output to
be routed to below decks, Cp B2 selects Co-Pol Band2, Cp B3 selects Co-Pol Band3 and Cp B4 selects Co-Pol Band4.
When you are finished making parameter changes, go to the SAVE NEW PARAMETERS display to save the changes you
have made.
TRACK DISP
Setting
Displayed band
selection
ADE Band Select Parameters
(Tone, Voltage & Aux Status)
0130 Xp B1
Xp B2
Xp B3
Xp B4
Cp B1
Cp B2
Cp B3
Cp B4
Tone OFF, Volt 13, Aux 0
Tone ON, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone ON, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone ON, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1
Tone ON, Volt 18, Aux 1