Installation manual
6009-33 Installation Manual Setup – Other Parameters
13-8
7
Click to redirect to the DAC Parameters 1 Page. This page presents the current
ACU configuration parameter values stored in the 68HC08 processor.
8
Click to redirect to the DAC Parameters 2 Page. This page presents the current
Satellite Tracking parameter values stored in the 68HC08 processor. This page also
contains the currently defined blockage zones (Az Limits 1-6).
9
Click to redirect to the Status page. This page presents current system status,
including Tracking condition, Antenna Position, Vessel Location / Orientation, and
decoded error conditions.
10
Click to redirect to the Home page. This page presents current system software
versions and antenna model configuration.
11
Click the SAVE button to store all current parameters in the operating software
variables table to Flash (Comm IF).
**THIS DOES NOT SAVE DISPLAYED PARAMETERS UNLESS THE SUBMIT BUTTON IS
PRESSED FIRST**
12
The M&C Baudrate field presents the J3 M&C Port Baud rate value currently stored
in the Comm IF Module. To change the Baud rate, type in the desired value and click
on the SUBMIT button or click on the SAVE button to store value to Flash.
Acceptable baud rate values are 4800 or 9600.
13
The NMEA A Baudrate field presents the J2 NMEA Port A Baud rate value currently
stored in the Comm IF Module. To change the Baud rate, type in the desired value
and click on the SUBMIT button or click on the SAVE button to store value to Flash.
Acceptable baud rate values are 4800 or 9600.
14
The NMEA B Baudrate field presents the J2 NMEA Port B Baud rate value currently
stored in the Comm IF Module. To change the Baud rate, type in the desired value
and click on the SUBMIT button or click on the SAVE button to store value to Flash.
Acceptable baud rate values are 4800 or 9600.
15
Click the SUBMIT button to transfer all currently displayed parameters to the
Comm IF module operating software variables table. NOTE: The submit button will
not store the values to flash; an ACU reset (hard or soft) will revert to the old settings.
13.10.3.
DAC Parameters Page 1