Installation manual

6009-33 Installation Manual Setup Other Parameters
13-10
13.10.4.
DAC Parameters Page 2
Number Description
1
Click to redirect to the Port Settings Page. This page presents the TCP connection and
baud rate settings for the Comm If Module.
2
Click to redirect to the DAC Parameters 1 Page. This page presents the current ACU
configuration parameter values stored in the 68HC08 processor.
3
Click to redirect to the DAC Parameters 2 Page. This page presents the current Satellite
Tracking parameter values stored in the 68HC08 processor. This page also contains the
currently defined blockage zones (Az Limits 1-6).
4
Click to redirect to the Status page. This page presents current system status, including
Tracking condition, Antenna Position, Vessel Location / Orientation, and decoded error
conditions.
5
Click to redirect to the Home page. This page presents current system software versions
and antenna model configuration.
6
Click the RELOAD button to refresh the screen to display the current ACU parameter
values
7
Click the SAVE button to store all currently displayed parameters to Flash (68HC08).
8
The SATELLITE field(s) present longitudinal position of the currently stored (or last
targeted) satellite. To change a parameter value mouse click inside the entry field and
type in the desired value. Refer to Setup (Section 5) of this manual for acceptable range
values.
9
These fields present 2 of the required 6 tracking parameters of the currently stored (or last
targeted) satellite. To change a parameter value mouse click inside the entry field and
type in the desired value. Refer to Setup (Section 5) of this manual for acceptable range
values.