Installation manual

Setup – Other Parameters 6009-33 Installation Manual
13-11
10
These fields present 3 of the required 6 tracking parameters of the currently stored (or last
targeted) satellite. To change this parameter value mouse click on the drop down menu
arrow and select desired parameter from list. Refer to Setup (Section 5) of this manual for
acceptable range values.
11
This field presents the Network Identification parameter currently stored for the desired
satellite. To change a parameter, value mouse click inside the entry field and type in the
desired HEX format value. Refer to Setup (Section 5) of this manual for acceptable range
values.
12
The BAND field presents the currently stored Tracking Band Selection in memory. To
change this parameter value mouse click on the drop down menu arrow and select desired
parameter from list. Refer to Setup (Section 5) of this manual for acceptable range values.
13
The Tx Polarity field presents the default Transmit Polarity parameter currently stored.
To change a parameter value mouse click inside the entry field and type in the desired
value Refer to Setup (Section 5) of this manual for acceptable range values.
14
The Az Limits 1-6 fields presents the defined blockage zones currently stored. To
change a parameter value mouse click inside the entry field and type in the desired value
Refer to Setup (Section 5) of this manual for acceptable range values.
15
Click the SUBMIT button to transfer all currently displayed parameters to the 68HC08
module operating software variables table. NOTE: The submit button will not store the
values to flash, an ACU reset (hard or soft) will revert to the old settings.
13.10.5. Status Page
Number Description
1
These fields presents the current antenna status.
2
Click to redirect to the Port Settings Page. This page presents the TCP connection and
baud rate settings for the Comm If Module.
3
Click to redirect to the DAC Parameters 1 Page. This page presents the current ACU
configuration parameter values stored in the 68HC08 processor.
4
Click to redirect to the DAC Parameters 2 Page. This page presents the current Satellite
Tracking parameter values stored in the 68HC08 processor. This page also contains the
currently defined blockage zones (Az Limits 1-6).
5
Click to redirect to the Status page. This page presents current system status, including
Tracking condition, Antenna Position, Vessel Location / Orientation, and decoded error
conditions.