Installation manual

DAC-2202 Technical Specifications 6009-33 Installation Manual
16-1
16. DAC-2202 Technical Specifications
The technical specifications for the DAC-2202 ACU and some of the specifications for general Below Decks are:
16.1. DAC-2202 Antenna Control Unit
The technical specifications for the DAC-2202 ACU are:
16.1.1.
Physical Dimensions: Rackmount: 1.75" x 17" x 14"
General
Input Voltage: 110/220 VAC, 50/60 Hz
Power Requirements: 160 Watts maximum (including the stabilized antenna pedestal and
TSC-10 Touch Screen Controller)
16.1.2.
Status Indicator Display: 6 LED enunciators for Tracking, Searching, Target, Power, Initializing,
and Error
Front Panel
Alpha Numeric Display: 2 Line 20 Character Alpha Numeric
Next Button Cycles display between Ship, Satellite, Antenna, and Status
4-Position Keypad Cycles cursor Up / Down / Left / Right
Enter Button
Reset Button
Controls: AC Power On/Off
16.1.3.
Connectors:
Rear Panel
J1 “Ship Gyro” 25 pin female D-Subminiature
J2 “NMEA” RS-422 Serial I/O 9 pin male D-Subminiature
J3 “M&C” RS-422 Serial I/O 9 pin female D-Subminiature
J4A “Antenna” RS-422 9 pin female D-Subminiature
Pedestal M&C
J4B “Antenna” Control IF and
Pedestal DC Power Type F female
J6 “RF IN” Tracking Receiver
IF Input Type F female
J7 “RF OUT” Tracking Receiver
IF Output Type F female
“Ethernet” RJ-45
“AC Input Power 95-250VAC” IEC receptacle
16.1.4.
Communications Parameters: 9600 Baud, 8 bits, No parity, 1Stop Bit
J4A “Antenna” Pedestal M&C Interface
Interface Protocol: Full Duplex RS-422
Base Modem Power: 30 Volts DC
Interface Connector: 9 pin male D-Subminiature