Installation manual

6009-33 Installation Manual 6009-33 Technical Specifications
17-4
Radio Interface (Jumper Selectable) RS-232, RS-422 (4 wire) or RS-485 (2 wire)
ADE/BDE Mode Jumper Selectable
17.6. Radome Assembly, 76”
Type Frequency Tuned
Material Composite foam/laminate
Size
Diameter: 201.59cm (79.37 inch)
Height: 200.99cm (79.13 inch)
Hatch size 18" x 28"
Installed weight MAX 233.6 kg (515 lbs.) Including antenna pedestal.
RF attenuation Less than 0.3 dB @ 10.7-12.75 GHz, dry
Less than 0.3 @ 14.0-14.5 GHz, dry
Wind: Withstand relative average winds up to 56 m/sec (125 mph) from
any direction.
Ingress Protection Rating All Sea Tel radomes have an IP rating of 56
Maintenance – The radome must be kept clean and free of residues that will increase the RF attenuation.
Repair - Any cracks, scratches or other damage to the surface seal of the radome must be repaired and re-sealed by
a competent “A” layered laminate (or cored deck) repair professional.
NOTE: Damage to the seal of the inside, or outside, of the radome can allow moisture to be absorbed. This will result
in the radome being heavier and having higher attenuation. Do NOT drill holes in this radome.
Disposal - Should it ever become necessary to dispose of the radome, it must be disposed of using the same
handling procedures as other fiberglass materials.
17.7. Radome Assembly, 81”
Type Frequency Tuned
Material Composite foam/laminate
Size
Diameter: 205.23cm (80.8 inch)
Height: 237cm (93.3 inch)
Hatch size 45.7 x 71.7cm (18 x 28 inch)
Installed weight MAX 800 lbs. (Including antenna pedestal), dry.
RF attenuation Less than 0.3 dB @ 10.7-12.75 GHz, dry
Less than 0.3 @ 14.0-14.5 GHz, dry
Wind: Withstand relative average winds up to 56 m/sec (125 mph) from
any direction.
Ingress Protection Rating All Sea Tel radomes have an IP rating of 56
Maintenance – The radome must be kept clean and free of residues that will increase the RF attenuation.
Repair - Any cracks, scratches or other damage to the surface seal of the radome must be repaired and re-sealed by
a competent “A” layered laminate (or cored deck) repair professional.
NOTE: Damage to the seal of the inside, or outside, of the radome can allow moisture to be absorbed. This will result
in the radome being heavier and having higher attenuation. Do NOT drill holes in this radome.
Disposal - Should it ever become necessary to dispose of the radome, it must be disposed of using the same
handling procedures as other fiberglass materials.
17.8. ADE Pedestal Power Requirements:
Antenna AC Input Power 100-240 VAC, 47-63 Hz, single phase
Antenna Power Consumption 450 Watts MAX (brake release, pedestal drive and 8W BUC
drive)