Installation Guide

INSTALLATION INSTRUCTIONS
Silhouette Comfort Plus
Tub/Shower Seat
LIFESTYLE & WELLNESS ®
LIFESTYLE & WELLNESS®
Patent Pending
Page 5
of 6
4. Attaching Seat Backrest to Seat Frame
Once all eight (8) screws have been tightened, install the Seat Backrest by placing the four (4) pins attached to the
backside of the phenolic seat backrest panel into the four (4) Key Hole Slots on the Seat Mounting Brackets.
The backrest panel should easily slide down approximately ½” until secure in its normal position.
Make certain all four (4) pins are engaged in each Key Hole Slot.
To remove the Seat Backrest, slide the backrest panel up approximately ½” so the four (4) pins align with the
enlarged portion of the Key Hole Slots on the Seat Mounting Brackets, and pull the backrest away from the frame.
NOTE:
The Seat Bottom Panel is attached to the aluminum frame at the factory using high-strength VHB tape.
Do NOT attempt to remove the Seat Bottom Panel from the seat frame as it may cause severe damage to the seat.