Installation Guide

Page 2 of 3
June 2022
INSTALLATION INSTRUCTIONS
SSB, SSL &
SSR SEATS
Diagram A
2. Determine seat height from the floor and location relative to the inside back wall.
ADA regulations specify a finished seat height of 17” to 19” above the finished floor and 1½” of clearance between
the seat edge and the side wall. Check local building codes for additional requirements.
Place the seat against the wall where
minimum 2” thick, solid wood in-wall
backing material is located and ensure the
appropriate finished seat height is at the
desired height and is level. (See Diagram A)
Verify that the seat edge is at the desired
distance from the side wall and is level and
plumb, and the sliding leg bracket fits flush
against the wall and is clear from the floor.
Upon selecting the height & location of the
seat, mark the three (3) holes on each of the
3” diameter mounting flanges (six [6] holes
total) on the wall where the seat will be
mounted. Use the Shower Seat Mounting
Flange Template (supplied by manufacturer)
as necessary.
Using a 1/8” Carbide tip drill bit (not
provided), drill at all six (6) locations.
Use clear silicone sealer at each hole location to prevent water damage to existing structures as desired.
3. Mounting the seat to the wall.
Holding the seat assembly in an
upright and raised position against
the wall, tightly secure the two
mounting flanges to the wall AND
INTO 2” THICK, SOLID WOOD IN-
WALL BACKING MATERIAL, using six
(6) #12 x 2½” stainless steel screws
(supplied by manufacturer).
Tighten screws completely AFTER all
screws are in place.