Operating instructions

72
DI Models
TYPICAL
1. PTO side spark plug cable
All Models
Start engine as explained above. If en-
gine continues to flood, see an autho-
rized SEA-DOO dealer.
Out of Fuel
DI Models
When running the engine out of fuel,
it may be necessary to remove and in-
stall the safety lanyard 2 - 3 times to
initially feed the fuel system after fuel
tank refill.
Towi ng the Watercraft in
Water
All Models
Special precautions should be taken
when towing a SEA-DOO watercraft in
water.
Maximum recommended towing speed
is 24 km/h (15 MPH).
When towing your watercraft in water,
pinch the water supply hose from the
impeller housing to the engine with a
large hose pincher (P/N 529 032 500).
This will prevent the cooling system
from filling which may lead to water be-
ing injected into and filling the exhaust
system. Without the engine running
there isn’t any exhaust pressure to car-
ry the water out the exhaust outlet.
CAUTION: Failure to do this may re-
sult in damage to the engine. If you
must tow a stranded watercraft in
water and do not have a hose pinch-
er, be sure to stay well below the
maximum towing speed of 24 km/h
(15 MPH).
Snugly install the hose pincher on the
water supply hose as shown.
GTI, GTI LE MODELS
1. Hose pincher

WARNING
Always reconnect spark plug ca-
bles at the same spark plugs where
they come from. The cable coming
out the edge of the electrical box
must be connected to the MAG side
spark plug.
1
F16H01Y
F01B23Y
F02E04Y
1
smo2003-001a.book Page 72 Monday, July 22, 2002 11:50 AM