Operating instructions

77
Periodic Inspection Chart
DESCRIPTION FREQUENCY
I: Inspect, verify, clean, adjust, lubricate,
replace if necessary
C: Clean
L: Lubricate
R: Replace
FIRST 10 HOURS EVERY 25 HOURS OR 3 MONTHS EVERY 50 HOURS OR 6 MONTHS EVERY 100 HOURS OR 1 YEAR TO BE PERFORMED BY
GENERAL
Lubrication/corrosion protection ➀ CC
ENGINE
Support and rubber mount I I D
Exhaust system fasteners ➄ IID
RAVE valve (if so equipped) ➄ CCD
Top end (leak test, piston and ring clearance)
(DI models only) ➄
➈ D
Counterbalance shaft oil level (if so equipped)IID
Spark plug ➃ IR D
Ignition timing (all models except DI) ➄ ID
TDC setting (DI models only) ➄➈D
COOLING
SYSTEM
Flushing ➂ CC
Hose condition and fasteners I I D
Engine drain tubes ➀ IC
Water flow regulator valve (if so equipped)ID
FUEL
SYSTEM
Carburetor including choke/throttle cable
(carburetor-equipped models)
IID
Throttle/choke cables (carburetor-equipped models) ➀ IC
Fuel filter (except RFI models) and lines I I D
Fuel filter (except DI and RFI models) RD
Fuel filter (DI models only) ➇ D
Oil leakage between cylinder head and injector
(DI models) ➄
IID
Fuel injection system sensors (except throttle body),
(RFI and DI models) ➄
IID
Throttle body and their sensors
(DI models) ➄ ➅
IID
Fuel vent line pressure relief valve I D
Fuel lines, connections (DI models), check-valve and
fuel system pressurization ➄
II D
Carburetors/throttle bodies, sensors, fuel lines, fuel rail
and fittings (if so equipped) ➄
IID
Air intake silencer fit/tightness I I D
Fuel tank straps I I C
LUBRICATION
SYSTEM
Oil injection pump ➄ IID
Oil filter and lines I I D
Oil filter RD
Oil reservoir straps I C
smo2003-001a.book Page 77 Monday, July 22, 2002 11:50 AM