Technical data

Section 06 FUEL SYSTEM
Sub-Section 01 (FUEL CIRCUIT)
06-01-6
1. Gasket in bowl
WARNING : Ensure that there is no leakage
from the fuel filter.
GTS and GTI Models Only
Insert vent tube in body and clip it in place.
WARNING : Vent tube must be in place to
provide proper bilge ventilation.
1. Install vent tube
INSPECTION
4, 5, Gear Clamp and Filler Neck Hose
Verify fuel filler neck hose for damage. Always en-
sure that clamps are well positioned and tight-
ened. Torque clamps to 4 N•m (35 lbf•in).
6, Pressure Relief Valve
This valve will eliminate fuel spillage when the
watercraft is upside down. If pressure is built up
in fuel system the valve should open at 10 kPa
(1.5 PSI) to release the pressure.
WARNING : If pressure relief valve is
stuck, the pressure in fuel system will
build up and it may cause fuel leakage in en-
gine compartment.
NOTE : It is a one-way valve with an arrow
to indicate the air flow.
7, Check Valve
Black side of the one-way check valve is the valve
outlet. It allows air to get in reservoir.
REMOVAL
8, Baffle Pick Up
NOTE : The baffle pick up has an integrated
fuel sensor on models which have a fuel
gauge.
1. Pick up tube
2. Fuel sensor
3. Baffle pick up
Disconnect BLACK negative cable, then RED pos-
itive cable of battery.
WARNING : Always disconnect battery
cables exactly in the specified order,
BLACK negative cable first. Electrolyte or fuel
vapors can be present in the engine compart-
ment and a spark might ignite them and possi-
bly cause personal injuries.
Empty fuel tank.
F01F02A
1
;
;
F02L14A
1
;
F01F20A
1
2
3
;
www.SeaDooManuals.net