Technical data

Section 06 FUEL SYSTEM
Sub-Section 01 (FUEL CIRCUIT)
06-01-7
WARNING : Fuel is flammable and explo-
sive under certain conditions. Always
work in a well ventilated area. Do not smoke or
allow open flames or sparks in the vicinity. Al-
ways wipe off any fuel spillage from the water-
craft.
All Models Except HX
Remove storage basket from watercraft.
On GTS and GTI models, remove vent tube. Refer
to fuel filter removal procedure in this sub-sec-
tion.
Disconnect filler neck hose from fuel tank.
Remove retaining straps from fuel tank and move
tank forward.
Remove hoses from baffle pick up and disconnect
wiring harness of fuel sensor (if applicable).
Remove lower clamp from baffle pick up adapter
and pull out baffle from fuel tank.
TYPICAL
1. Wiring harness
2. Baffle pick up adapter
HX Model Only
Pull down left vent tube.
1. Vent tube
Cut tie rap retaining fuel hoses to tie-mount.
1. Cut tie rap
All Models
Loosen lower clamp of baffle pick up adapter and
pull out baffle from fuel tank.
Remove upper clamp from adapter and slide
adapter from baffle.
Inspect filter of baffle pick up. Clean or replace as
necessary.
ASSEMBLY
Assembly is essentially the reverse of disassem-
bly procedures. However pay particular attention
to the following.
Slide adapter onto baffle pick up until it stops on
rib. Install clamp.
;
F01F21A
12
F05L14A
1
F05F02A
1
www.SeaDooManuals.net