Technical data

Section 08 ELECTRICAL SYSTEM
Sub-Section 01 (MAGNETO SYSTEM)
08-01-9
4,5, Armature Plate and Screw
Position the armature plate on the crankcase,
aligning the marks on both parts.
Apply a drop of Loctite 242 (blue) on screw
threads and torque to 6 N•m (53 lbf•in).
3,14,15, Magneto Flywheel, Woodruff
Key and Nut
Apply Loctite 242 (blue) on crankshaft taper.
Position Woodruff key and magneto flywheel. Ap-
ply Loctite 242 (blue) on nut threads. Install nut
with lock washer and torque to 145 N•m (107
lbf•ft).
CAUTION : Never use any type of impact
wrench at magneto installation.
Ignition Timing
For procedures, refer to ELECTRICAL SYSTEM
08-02.
787 Engine
11,18, Magneto Housing and Seal
To install oil seal of magneto housing, use pusher
(P / N 290 877 740) and handle (P / N 290 877
650).
1. Pusher
2. Handle
11,12,13, Magneto Housing, Gasket and
Screw
Install gasket between magneto housing and en-
gine crankcase.
Install magneto housing and torque screws to 9
N•m (80 lbf•in).
15,16,17, Rotor Flywheel and Nut
When reinstalling magneto rotor to engine fly-
wheel, apply Loctite 648 to mating surfaces.
One of the protuberance end of magneto rotor
must align with hole of engine flywheel.
1. Protuberance
2. Hole
Apply Loctite 242 (blue) on crankshaft taper.
Apply Loctite 242 (blue) on nut threads. Install nut
with lock washer and torque to 105 N•m (77
lbf•ft).
-
F01B2NA
1
2
F04D0CA
F01D83A
112
www.SeaDooManuals.net