Technical data

Section 09 PROPULSION SYSTEM
Sub-Section 01 (JET PUMP)
09-01-9
14,15, Boot and Ring
Pull out ring from boot
1. Pull out ring
Insert a screwdriver blade between impeller and
boot flange. Carefully pry boot all around to re-
lease from impeller.
1. Pry boot out
Withdraw drive shaft.
NOTE : A jammed drive shaft can be re-
moved by holding pump unit by drive shaft,
slightly raised unit above a soft surface, then
strike all around impeller housing with a fiber ham-
mer. Corroded parts can be loosened by applying
BOMBARDIER LUBE lubricant (P / N 293 600
016).
1. Hold raised with drive shaft while striking
16, Fitting
Fittings can be removed with deep socket or vise
grip. Do not contact hose mounting area.
Fitting can be removed from pump housing with
the following suggested tool :
– Use a 14 mm (9/16 in) deep socket.
– Drill deep socket with a 14 mm (9/16 in) drill bit,
starting at hexagone head end as shown in fol-
lowing illustration.
– Drill a 2.40 mm (3/32 in) hole in center of deep
socket as shown in following illustration.
– Install 2.40 mm (3/32 in) roll pin in the center
hole.
1. Deep socket 14 mm (9/16 in)
2. Roll pin 2.40 mm (3/32 in)
A. 42.50 mm (1-43/64 in)
B. 36.80 mm (1-29/64 in)
F01J09A
1
F01J0RA
1
F01J0SA
1
F01J2RA
A
B
2
1
www.SeaDooManuals.net