Technical data

Section 09 PROPULSION SYSTEM
Sub-Section 01 (JET PUMP)
09-01-18
Apply Loctite 518 (P / N 293 800 038) to seal hous-
ing, all around outer diameter and on seal seat.
Properly insert seal on tool.
NOTE : It is important when installing seals
to pack seal lip with grease before inserting
bearing / seal installer tool. Properly insert tool in
seal with a rotating movement.
1. Raised edge of seal this side
CAUTION : Prevent sealant from contact-
ing any needles of bearing.
Push on tool end with a press until tool flange con-
tacts housing.
1. Press on tool until it stops
Apply synthetic grease (P / N 293 550 010) be-
tween seal lips.
1. Loctite 518 all around and behind
2. Raised edge of seal lip this side
7,19,23,24,25, Impeller Housing,
Impeller, Impeller Shaft, Thrust Washer
and Thrust Bearing
Insert impeller shaft flats in a vise so that shaft is
vertical.
Apply Sea-Doo jet pump synthetic oil (P / N 293
600 011) on both sides of thrust bearing then in-
sert onto shaft followed by thrust washer. Make
sure bearing is leaning against shaft flange and
washer is properly centered. Oil will prevent parts
from sliding at installation and thus possibly
wedging thrust bearing into shaft groove.
CAUTION : It is critical to keep thrust bear-
ing and washer properly centered on
shaft during assembly of pump.
1. Apply oil on faces of parts to prevent them to slide and wedge
into shaft groove
F01J1KA
1
-
F01J1LA
1
F01J1MA
1
2
-
F01J1NA
1
www.SeaDooManuals.net