Technical data

Section 09 PROPULSION SYSTEM
Sub-Section 01 (JET PUMP)
09-01-24
1. O-ring
2. Floating ring
Position the floating ring between the carbon ring
and the PTO flywheel boot.
1. Floating ring
Install jet pump with drive shaft.
CAUTION : Some watercraft require a
shim between hull and pump ; if shim has
been removed at pump removal, be sure to re-
install it, otherwise engine alignment will be
altered.
CAUTION : Take care not to break the O-
ring in the floating ring flange while in-
serting the drive shaft.
Engage drive shaft splines in PTO flywheel. Ro-
tate shaft to properly index splines. Make sure
boot is well positioned over shaft end.
Apply Loctite 242 (blue) on stud threads of jet
pump housing.
Install flat washers, lock washers and nuts. Tight-
en nuts of impeller housing in a criss-cross se-
quence and torque to 35 N•m (26 lbf•ft).
Push the floating ring to compress the protective
hose. Insert the O-ring in the drive shaft groove.
Step Push floating ring
Step Insert O-ring in the groove
Slide the floating ring onto the O-ring.
Secure small clamp of PTO flywheel boot. Refer
to PROPULSION SYSTEM 09-02.
Using a grease gun, carefully lubricate PTO fly-
wheel with synthetic grease (P / N 293 550 010),
until boot is just beginning to expand. At this
point, immediately stop greasing.
Secure water inlet hose and both bailer tubes to
impeller housing using tie raps.
F01I0DA
1
2
F02I03A
1
-
-
F02I04A
1 2
1
2
F01I0BB
www.SeaDooManuals.net