Technical data

ManualsBrandsSeaDoo ManualsMarineSP

221

222

223

224

225

226

227

228

229

230

Section 09 PROPULSION SYSTEM

Sub-Section 01 (JET PUMP)

09-01-25

1. Bailer tubes

2. Water inlet hose

Secure flywheel guard to engine studs using 1 nut

and 1 washer on each side of guard.

Reinstall air vent tube support onto body (SP / XP

series).

HX Model Only

Make sure rear drive shaft is properly installed.

Install jet pump. If necessary, wiggle jet pump to

engage drive shaft splines in impeller.

Install flat washers, lock washers and nuts. Tight-

en nuts of impeller housing in a criss-cross se-

quence and torque to 31 N•m (23 lbf•ft).

SP, GTS and GTI Models

1,2,3,4,5, Screw, Sleeve, Bushing,

Locking Disk and Nozzle

Insert bushings in nozzle, positioning their flanges

from inside of nozzle.

Insert sleeves in bushings.

Install nozzle on venturi ; position its steering arm

on RH side. Apply Loctite 242 (blue) on screw

threads (or use new screws with pre-applied Loc-

tite). Install screws and locking disks then torque

to 20 N•m (15 lbf•ft).

TYPICAL

1. Locking disks

2. Torque to 20 N•m (15 lbf•ft)

WARNING : Whenever removing screw

always renew locking disks. Screw must

be torqued as specified.

Steering and Reverse Cables

Secure ball joints of steering cable and reverse ca-

ble (GTS and GTI models).

TYPICAL

ALUMINUM NOZZLE

1. Ball joint on top of arm

2. Torque nut to 7 N•m (62 lbf•in)

F01J0IA

F01J3BA

;

F01J4YB