Technical data

Section 09 PROPULSION SYSTEM

Sub-Section 01 (JET PUMP)

09-01-26

TYPICAL

PLASTIC NOZZLE

1. Torque nut of steering cable ball joint to 7 N•m (62 lbf•in)

2. Torque nut of reverse cable ball joint to 7 N•m (62 lbf•in)

(if applicable)

HX, SPI, SPX and XP Models

5, Nozzle

Install nozzle / trim ring assembly.

Torque screws to 14 N•m (10 lbf•ft).

NOTE : Trim ring has a tight fit ; to install,

insert both sides at the same time, taking

care not to break plastic bushings. Carefully use a

plastic tip hammer if necessary. Make sure steer-

ing arm of jet pump is on right side and trim arm

is above venturi housing.

1. Torque screws to 14 N•m (10 lbf•ft)

Steering Cable

Secure ball joint of steering cable.

TYPICAL

1. Ball joint on top of arm

2. Torque nut to 7 N•m (62 lbf•in)

Trim Systems

SPX and XP Models

Secure ball joint of VTS link rod

1. Torque nut to 10 N•m (89 lbf•i

)

F02J02C

F01J5FA

F01J58A

F01J08C