Technical data

Section 09 PROLPUSION SYSTEM
Sub-Section 02 (DRIVE SYSTEM)
09-02-7
HX Model Only
PTO flywheel is loosen using flywheel remover.
1. PTO flywheel remover
DISASSEMBLY
HX Model Only
13,14, Seal and Needle Bearing
To remove seals and bearing, use a 30 mm (1-1/8
in) diameter by 345 mm (13-1/2 in) long steel
shaft. Machine shaft as per the following drawing.
NOTE : The same tool is used for bearing
and seal removal of jet pump.
A. 22 mm (.865 in) dia.
B. 28 mm (1.115 in) dia.
C. 90 mm (3-1/2 in)
D. 345 mm (13-1/2 in)
Properly support seal carrier when removing seals
and bearing.
PARTS INSPECTION
3, Drive Shaft
Inspect condition of splines.
Inspect condition of groove.
With your finger nail, feel contact surface of float-
ing ring. If any irregular surface is found, renew
drive shaft.
1. Floating ring contact surface
2. Groove condition
3. Splines condition
Excessive deflection could cause vibration and
damage to drive shaft splines, impeller, flywheel
or floating ring.
F05I0CA
1
F05I0DA
F01J11A
A B
C
D
D
F01I0FA
3
2
1
www.SeaDooManuals.net