Technical data

Section 09 PROLPUSION SYSTEM

Sub-Section 02 (DRIVE SYSTEM)

09-02-10

Install alignment tool at rear of watercraft.

1. Housing (P / N 295 000 090)

2. Alignment shaft (P / N 295 000 093)

Carefully slide shaft through seal carrier.

1. Alignment tool

2. Seal carrier

Torque seal carrier nuts to 10 N•m (89 lbf•in) in a

criss-cross sequence as per following illustration.

NOTE : It is very important to tighten nuts of

seal carrier in a criss-cross sequence to

maintain its alignment.

4,7,16,17, Drive Shaft, Damper and

Bushing

Make sure to install damper and bushing on both

drive shafts.

1. Damper

2. Bushing

All Models Except HX

1, Large Clamp

– Secure large clamp as follows :

– Use pliers (P / N 295 000 069) as for removal.

– Manually engage holding hook in large window.

This is a pre-clamping position only.

F01L2RC

F05I07A

F05I08A

1 2

F05I0EA

F05I0FA