Technical data

Section 09 PROPULSION SYSTEM
Sub-Section 03 (REVERSE SYSTEM)
09-03-2
GENERAL
It is not necessary to remove reverse system
from watercraft for servicing. However reverse
system removal is necessary to replace reverse
support.
DISASSEMBLY
Remove storage basket from watercraft.
Press on vent tube upper part to enable to with-
draw tube from body.
TYPICAL
1. Press on vent tube
1,2,3, Locking Lever, Spring and
Selector Lever
To remove selector lever, unhook spring from
sliding block and pull spring from selector lever
stem.
TYPICAL
1. Sliding block
2. Spring
Withdraw selector lever stem and locking lever
from sliding block, then slide off locking lever
from stem.
TYPICAL
1. Locking lever
4,5, Triangular Lever and Sliding Block
Remove screw, lock nut, washers and bushing
holding reverse cable to triangular lever.
Remove lock nut and washer holding sliding block
to triangular lever and to support.
Remove screw, lock nut, washer and bushing
holding triangular lever to reverse support.
F02L1MA
1
F02J04A
1
2
F02J05A
1
www.SeaDooManuals.net